Many of the bridges, garages, and buildings in service today were designed for loads and conditions that have since changed. Replacing them is costly and disruptive, which is why strengthening existing concrete in place keeps gaining ground.
Carbon fiber reinforced polymer (CFRP) bonded to concrete is one of the most widely studied ways to do that. The research also shows where it needs careful design.
What Is CFRP Strengthening?
A Colorado DOT/FHWA evaluation of an FRP-retrofitted arch bridge describes fiber-reinforced polymers as non-corrosive, lightweight, non-conductive, and very strong in tension.
Two installation approaches appear throughout the field research. Externally bonded systems glue carbon fabric or plates to the concrete surface with epoxy. Near-surface-mounted systems set FRP bars into grooves cut in concrete.
Strengthening Concrete in Place
The Federal Highway Administration’s report on bridge strengthening techniques lists FRP alongside concrete jacketing, steel plate bonding, and external post-tensioning as established options.
The Missouri DOT strengthened a three-span concrete slab bridge using both techniques and found that each was easily implemented and performed satisfactorily. The bridge’s load posting was removed, and a load test 12 months later found no further deck cracking. Researchers at Purdue, working with INDOT and FHWA, evaluated both methods on deteriorated beams, with a focus on adjacent box beam bridges.
Gains should be set realistically. In the Colorado study, retrofitted test beams were 22% to 30% stronger in bending than control beams, but the increase was smaller than expected.
Debonding and the Ductility Trade-Off
A review in Construction and Building Materials identifies brittle debonding as a central concern and says it can significantly reduce a strengthening application’s effectiveness if the design does not account for it.
The Colorado tests showed why. In one specimen the FRP ruptured earlier than expected, and in another the concrete peeled away, causing bond failure of the FRP rods. A 2024 review in the International Journal of Concrete Structures and Materials adds that designers must balance added load capacity against lost ductility.
Design Standards Arrived Late
When NCHRP Report 655 was published in 2010, it noted that externally bonded FRP had become accepted practice at some state agencies. It also said the lack of nationally accepted bridge design specifications was holding back wider use.
Fire Performance
Polymer matrices soften as temperatures rise. A state-of-the-art review of FRP-strengthened concrete members reports significant performance degradation at elevated temperatures and says fire protection systems are often needed. The Colorado report notes that the epoxy begins to decompose at 446°F.
Protection can work. Full-scale fire tests of three FRP-wrapped columns at the National Research Council of Canada, summarized in NIST’s fire research database, showed that appropriately insulated columns can achieve satisfactory fire endurance even though the FRP itself is heat-sensitive.
Long-Term Performance Is Still Being Studied
An Indiana DOT/FHWA study states that the long-term performance of FRP-wrapped columns in severe environments had not been fully assessed.
In Colorado, pull-off tests after exposure to water, freeze-thaw cycles, deicing salt, and high temperature showed bond strengths that met the acceptance criterion but were significantly affected by the exposures. The report recommends considering degradation in design and continuing to monitor the bridge.






